Action0/Vehicles/Planes
Action 0 properties for planes
Action 0 - Properties for planes
Defining properties of planes.
{maketoc}
-=Properties=-
||Number|Version|Size|Description
08| |B|Sprite (FF for new graphics)
09| |B|Is helicopter? 2=no, 0=yes
0A| |B|Is large? 0=no, 1=yes (i.e. can't safely land on small airports)
0B| |B|Cost factor
0C| |B|Speed in mph*8
0D| |B|Acceleration
0E| |B|Running cost factor
0F| |W|Passenger capacity
11| |B|Mail capacity
12| |B|Sound effect
13|6|D|Bit mask of cargo types available for refitting, see column 2 (Bit Value) in CargoTypes
14|6|B|Callback flags bit mask, see below
15|(a)|B|Refit cost, using 1/32 of the default refit cost base
16|(b)|B|Retire vehicle early, this many years before the end of phase 2 (see Action0General)
17|(c)|B|Miscellaneous vehicle flags
18|(c)|W|Refittable cargo classes, see train prop. 28
19|(c)|W|Non-refittable cargo classes, see train prop. 29
1A|(d)|D|Long format introduction date||
Version codes:
||Code|Version
(a)|2.0.1 alpha 30
(b)|2.0.1 alpha 44
(c)|2.0.1 alpha 58
(d)|OpenTTD r7191||
-=Comments=-
Sound effect (12)
The following sound effects are used by planes (note, the setting is ignored for helicopters):
||Number|Sound
06|Propeller sound 1
07|Jet sound 1
3B|Supersonic
3D|Jet sound 2
45|Propeller sound 2
46|Jet sound 3||
Callbacks (14)
For planes, the following callbacks have to be enabled by setting the corresponding bit in property 14 (certain other, not as frequently used callbacks are available without setting a bit here)::
||Bit|Value|Variable 0C value|Callback
2|4|12|Load amount
3|8|15|Set refitted capacity
5|20|19|show a suffix after the cargo type name
6|40|2D|Select color mapping for vehicle
7|80|33|Sound effect callbacks||
Bit is the bit you have to set, you do this by adding all the values for all the bits. Variable 0C value is what variable 0C will be set to, for checking it in the variational action 2 for callbacks.
Miscellaneous flags (17)
This is a bit mask, with the following bits:
||Bit|Value|Meaning
0|1|reserved, do not use
1|2|Uses two company colors||
Long format introduction date (1A)
Set the vehicle introduction date, in days since the year 0. This takes account of leap years; dividable by 4, but not 100 unless 400. A start date of 1920-01-01 is obtained with a value of 701265 (51 B3 0A 00). This property must be set after property 00 to take effect. (OpenTTD only)
